![]() ![]() ) to transfer the file might be a better way. Using a single-port protocol (SFTP, HTTP. You might want to reconsider your entire approach to transferring files. Excerpt from the WinSCP manual:Īs WinSCP does not allow configuring a range of the ports it uses for data connections, all ports in Windows dynamic port range 49152 - 655354) have to be opened. You have executed command from command-line on Commander interface. You will see it in following cases: You have explicitly asked to open it using command Commands > Open Terminal or respective toolbar button. You can use Generate Session URL/Code command to generate the open command for a given stored site. Console window can be used to execute remote commands and see their output. Most clients do not support configuration or control of the data port range. With session URL, you typically specify a protocol, host name, username and password, optionally also a port number and SSH host key fingerprint. However, the behavior of ftp.exe cannot be controlled/modified. Now that it’s clear that this question is about ftp.exe, the explanation above is mostly irrelevant because ftp.exe only supports Active FTP. While still problematic with firewalls because it’s not a “known” port, it is fully supported on NAT routers without FTP helpers. If you are not using pageant to manage your ssh keys, you have to point WinSCP to the private key file (in PuTTY. Now, the client has to initiate to connection to the IP address and port indicated in the server reply ( 227 Entering. But with Passive FTP, the client cannot decide on which port to use. ![]() Thus, Passive FTP is now the de-facto standard. With Passive FTP, it’s the opposite: the client opens additional connections to the server. ![]() This is not suitable for clients behind firewalls or NAT routers. However, with Active FTP the server will connect to the client. The two numbers at the end are the higher and lower 8 bit of the 16 bit port number. Only with Active FTP can the client decide on which ports to use, using the PORT command. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |